LX-3™ Specifications

The LX-3 is a simple yet very powerful problem-solving device. It allows you to split any line-level signal to up to three destinations simultaneously without signal degradation or noise. The heart of this unit is the Jensen® JT-123-FLPCH transformer, which boasts an exceptionally wide bandwidth, low distortion, and minimal deviation from linear phase. Two isolated outputs help eliminate buzz and hum from ground loops, and an input pad allows very hot line-level signals to be used without distortion. An additional direct output is also available for connection to a third destination, and all outputs have ground lifts for further noise abatement. A 14-gauge solid steel enclosure helps protect against signal interference and prevents the circuit board from being torqued.

Audio Circuit Type:  Passive, transformer based
Frequency Response: 20Hz - 20kHz +/-0.5dB
Total Harmonic Distortion:  <0.001% @ 1kHz
Dynamic Range:  140dB
Gain: -1.5dBu
Maximum Input: +20dBu
Noise Floor:  -120dBu
Phase Deviation:  +0.6° @ 20Hz
Common Mode Rejection:  105dB @ 60Hz, 70dB @3kHz
Input Impedance:  712Ω
Output impedance:  112Ω 
Transformer: Jensen JT-123-FLPCH
Input Pad: -12dB
Ground Lifts: Disconnects pin-1 at XLR output
XLR Configuration: AES standard (pin-2 hot)
Connectors: Combo XLR/¼" input, XLR-M iso and direct out
Construction:  14-gauge steel
Finish: Durable Powder Coat
Size (L x W x H): 84mm x 127mm x 48mm (3.3" x 5" x 2")
Weight: 0.7kg (1.5lbs)
Shipping Size (L x W x H): 102 x 76 x 165mm (4" x 3" x 6.5")
Shipping Weight: 0.87 kg (1.92 lbs)
Conditions:  For indoor use at temperatures between +5°C and +40°C
Warranty:  Radial 3-year, transferable
Specifications are subject to change without notice.