MIX 2:1™ Specifications

The MIX 2:1 uses a completely passive circuit that requires no power to operate and allows you to sum two signals together with minimal coloration or distortion. Either signal can be attenuated to create the desired blend between the two, or the level controls can be bypassed altogether, summing each input equally. The MIX 2:1 automatically compensates for the 6dB in voltage gain when summing two in-phase signals together, so you don’t overload the next device in your signal chain. Ground lift switches are provided to remove buzz and hum from ground loops, and the MIX 2:1 is housed in a rugged steel chassis to handle use in the studio and on the road.

Audio Circuit Type:  Passive mixer
Frequency Response: 20Hz to 20kHz
Noise Floor: -113dBu
Dynamic Range:  >133dB
Maximum Input: >+ 20dBu
Gain: N/A
Intermodulation Distortion: >0.002% @ 0dBu
Total Harmonic Distortion: >0.005% @ 0dBu
Common-Mode Rejection Ratio: >80dB
Phase Deviation: 0° @ 20Hz, 0° @ 1kHz, +2° @10kHz
Input Impedance: 8 kΩ
Output Impedance: 1 kΩ
Insertion Loss: -6dBu
Input Connections: ¼" / XLR
Switches: 180° phase, ground lift
Output Connector: XLR
Extras: Level Control with defeat
On/Off switch for each input
Power:  Passive, no power required
Construction:  14-gauge steel chassis and outer shell
Finish: Durable powder coat
Size (L x W x H): 5" x 3.25" x 1.85" (12.7 x 8.3 x 4.7cm)
Weight: 1.48lb (0.67kg)
Shipping Size (L x W x H): 6.25" x 4.12" x 3" (15.9 x 10.5 x 7.6cm)
Shipping Weight: 1.77lb (0.8kg)
Conditions: For use in dry conditions between 5°C and 40°C
Warranty:  Radial 3-year, transferable
Specifications are subject to change without notice.