Output-1 Level
Lets you adjust the output level to amp-1 right from the control room. This is particularly useful for fine-tuning front end drive distortion.
On-Off
Lets you mute the output going to amp-1.
Lift
Lifts the ground on the ¼” cable so it eliminates a potential ground loop between the 500 series rack and the guitar amp.
Output-2 Level
Lets you adjust the output level to amp-2 right from the control room. This is particularly useful for fine-tuning front-end drive distortion.
On-Off
Lets you mute the output going to amp-2.
180°
Reverses the phase going to amp-2 to time-align the amps if needed; can also be used to create some interesting effects.
Lift
Lifts the ground on the ¼” cable so that it eliminates a potential ground loop between the 500 series rack and the guitar amp.
Outputs
Two outputs let you drive two amps at the same time. These are transformer isolated to help eliminate hum and buzz caused by ground loops. Class-A buffered to let you drive long cables.
OmniPort
Configured as a Hi-Z guitar input to allow the X-Amp to be used like an ABY box to allow a guitarist to play two amps at once.
